Step 2: Set up your iPad stand

Black iPad stand

Press play on the video below and start setting up your new iPad stand.

All done? You can go ahead and proceed to the next step: Set up your printer and cash drawer.

To the next step →

White iPad stand

Remove the items from the box and make sure you have:

  • Main support

  • Narrow plastic component

  • Large plastic component

  • 4 screws

  • Allen key

In addition, you should have:

  • Your iPad

  • iPad charging cable

Follow the next steps along with the the images above:

Step 1:

1.1. Feed through the iPad charging cable below the main support, keeping the side of the cable that connects to the iPad facing up.

1.2. Feed the cable through the opening of the wide plastic lid.

1.3. Insert the plastic cap, then press into place.

Step 2: Insert the two screws and tighten them with the Allen key.

Step 3: Adjust the iPad cable by pressing it down to fit into the wire channel.

Step 4: Slide the iPad from right to left, making sure the charging port is pointing to the right.

Step 5: Make sure the iPad cable is in place and position the plastic cover on the side of the stand. Check that the 3 flaps of the cover are correctly positioned in the support, insert the screws and tighten them with the Allen key.

Step 6: Plug the charging cable into the charging port of the iPad.

All done? You can go ahead and proceed to the next step: Set up your printer and cash drawer.

To the next step →